50 SEATS AND RESTRAINTSA DIC welcome message mayindicate driver number 1 or 2.2. Adjust all available memoryfeatures to the desired drivingposition.3. Press and release SET; a beepwill sound.4. Immediately press and hold the1 or 2 memory button matchingthe above DIC welcome messageuntil two beeps sound.If too much time passes betweenreleasing SET and pressing 1, thememory position will not besaved and two beeps will notsound. Repeat Steps 3 and 4.1 or 2 corresponds to the drivernumber. See “Identifying DriverNumber” previously in thissection.5. Repeat Steps 1–4 for a seconddriver using 1 or 2.To save the position for B and SeatExit Memory features, repeat Steps 1–4 using B. This saves the positionfor getting out of the vehicle.Save preferred memory featurepositions to both 1 and 2 if you arethe only driver.Manually Recalling MemoryPositionsPress and hold 1, 2, or B to recallthe previously saved memorypositions if you are driver 1 or 2identified in the DIC welcomemessage. RKE transmitters 3–8 willnot recall memory positions.To stop Manual Memory recallmovement, release 1, 2, or B or pressany of the following controls:. Power seat. Memory SET. Power mirror, with the driver orpassenger side mirror selected. Power steering wheelSeat Entry MemoryIf equipped with memory seat 1, 2,or B buttons on the passenger door,those positions must be recalledmanually. They will not be linked toan RKE transmitter.The vehicle identifies the number ofthe current driver’s RKE transmitter(1–8). See Remote Keyless Entry (RKE)System Operation 0 10. If the RKEtransmitter is 1 or 2, and Seat EntryMemory is enabled in vehiclepersonalization, the positions saved tothe same memory button number 1 or2 are automatically recalled when thevehicle is turned on, or turned fromoff to ACC/ACCESSORY. RKEtransmitters 3–8 will not provideautomatic memory recalls.To turn Seat Entry Memory on or off,see “Vehicle Personalization Settings”previously in this section and VehiclePersonalization 0 140.The shift lever must be in P (Park) tostart Seat Entry Memory. Seat EntryMemory recall will complete if thevehicle is shifted out of P (Park) priorto reaching the saved memoryposition.To stop Seat Entry Memory recallmovement, turn the vehicle off orpress any of the following controls:. Power seat. Memory SET, 1, 2, or B
