Interfaces | 259CommandHistoryExample Figure 14-27. show config (Bulk Configuration) Command Exampleshow interfacesDisplay information on a specific physical interface or virtual interface.Syntax show interfaces interfaceParametersCommand Modes EXECEXEC PrivilegeCommandHistoryUsage Use this show interfaces command for details on a specific interface. Use the show interfacesstack-unit command for details on all interfaces on the designated stack unit.On the MXL Switch, the show interface output displays incorrect rate information details over time forlink monitoring when the rate-interval is configured for 5 seconds. Dell Force10 recommends usinghigher rate-intervals such as 15 to 299 seconds to minimize the errors seen.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO ModuleFTOS(conf)#interface range tengigabitethernet 1/1 - 2FTOS(conf-if-range-tengig-1/1-2)#show config!interface TenGigabitEthernet 1/1no ip addressswitchportno shutdown!interface TenGigabitEthernet 1/2no ip addressswitchportno shutdownFTOS(conf-if-range-tengig-1/1-2)#interface Enter one of the following keywords and slot/port or number information:• For a Loopback interface, enter the keyword loopback followed by a number from 0 to16383.• For the management interface, enter the keyword ManagementEthernet followed bythe slot/port information. The slot range is 0 to 1 and the port range is 0.• For a Null interface, enter the keywords null 0.• For a Port Channel interface, enter the keyword port-channel followed by a number:Range: 1 to 128• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed bythe slot/port information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/portinformation.• For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO ModuleNote: In the CLI output, the power value will be rounded to a 3-digit value. For receive/transmit power that is less than 0.000, an snmp query will return the corresponding dbm valueeven though the CLI displays as 0.000.