572 | sFloww w w . d e l l . c o m | s u p p o r t . d e l l . c o mCommandsThe sFlow commands are:• sflow collector• sflow enable (Global)• sflow enable (Interface)• sflow extended-switch enable• sflow polling-interval (Global)• sflow polling-interval (Interface)• sflow sample-rate (Global)• sflow sample-rate (Interface)• show sflow• show sflow stack-unitsflow collectorConfigure a collector device to which sFlow datagrams are forwarded.Syntax sflow collector {ipv4-address} agent-addr {ipv4-address} [number [max-datagram-sizenumber]] | [max-datagram-size number]To delete a configured collector, use the no sflow collector {ipv4-address} agent-addr{ipv4-address} [number [max-datagram-size number]] | [max-datagram-size number] command.ParametersDefaults Not configuredCommand Modes CONFIGURATIONCommandHistoryUsageInformationYou can configure up to two sFlow collectors (IPv4). If two collectors are configured, traffic samplesare sent to both.The sFlow agent address is carried in a field in SFlow packets and is used by the collector to identifythe sFlow agent.sflow collector ipv4-address Enter the IPv4 (A.B.C.D) of the sFlow collector device.agent-addr ipv4-address Enter the IPv4 (A.B.C.D) of the sFlow agent in the router.number (OPTIONAL) Enter the UDP port number (User DatagramProtocol).Range: 0 to 65535Default: 6343max-datagram-size number (OPTIONAL) Enter the keyword max-datagram-sizefollowed by the size number in bytes.Range: 400 to 1500Default: 1400Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
