Link Aggregation Control Protocol (LACP) | 333UsageInformationThis command applies to dynamic port-channel interfaces only. When applied on a static port-channel,the command has no effect.RelatedCommandslacp port-priorityConfigure the port priority to influence which ports will be put in standby mode when there is ahardware limitation that prevents all compatible ports from aggregating.Syntax lacp port-priority priority-valueTo return to the default setting, use the no lacp port-priority priority-value command.ParametersDefaults 32768Command Modes INTERFACECommandHistorylacp system-priorityConfigure the LACP system priority.Syntax lacp system-priority priority-valueParametersDefaults 32768Command Modes CONFIGURATIONCommandHistoryport-channel modeConfigure the LACP port channel mode.Syntax port-channel number mode [active] [passive] [off]show lacp Displays the lacp configurationpriority-value Enter the port-priority value. The higher the value number the lower the priority.Range: 1 to 65535Default: 32768Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Modulepriority-value Enter the system-priority value. The higher the value, the lower the priority.Range: 1 to 65535Default: 32768Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
