Storm Control | 607Example Figure 32-2. show storm-control multicast Command Exampleshow storm-control unknown-unicastDisplay the storm control unknown-unicast configurationSyntax show storm-control unknown-unicast [interface]ParametersDefaults noneCommand Modes EXECEXEC PrivilegeCommandHistoryExample Figure 32-3. show storm-control unknown-unicast Command Examplestorm-control broadcast (Configuration)Configure the packets per second of broadcast traffic.Syntax storm-control broadcast [packets_per_second] inTo disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second] incommand.FTOS#show storm-control multicast tengigabitethernet 1/0Multicast storm control configurationInterface Direction Packets/Second-----------------------------------------------TenGig 1/0 Ingress 5FTOS#interface (OPTIONAL) Enter one of the following interfaces to display the interface specific stormcontrol configuration.• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed bythe slot/port information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO ModuleFTOS#show storm-control unknown-unicast tengigabitethernet 3/0Unknown-unicast storm control configurationInterface Direction Packets/Second-----------------------------------------------TenGig 3/0 Ingress 1000FTOS#