Virtual Router Redundancy Protocol (VRRP) | 665debug vrrp Allows you to enable debugging of VRRP.Syntax debug vrrp interface [vrrp-id] {all | packets | state | timer}To disable debugging, use the no debug vrrp interface [vrrp-id] {all | packets | state | timer}command.ParametersCommand Modes EXEC PrivilegeCommandHistoryUsageInformationIf no options are specified, debug is active on all interfaces and all VRRP groups.description Configure a short text string describing the VRRP group.Syntax description textTo delete a VRRP group description, use the no description command.ParametersDefaults Not enabled.Command Modes VRRPCommandHistoryinterface Enter the following keywords and slot/port or number information:• For Port Channel interface types, enter the keyword port-channel followed by thenumber:Range: 1 to 128• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernetfollowed by the slot/port information.• For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLANID range is from 1 to 4094.vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.all Enter the keyword all to enable debugging of all VRRP groups.bfd Enter the keyword bfd to enable debugging of all VFFP BFD interactionspackets Enter the keyword packets to enable debugging of VRRP control packets.state Enter the keyword state to enable debugging of VRRP state changes.timer Enter the keyword timer to enable debugging of the VRRP timer.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Moduletext Enter a text string up to 80 characters long.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
