96 | Access Control Lists (ACL)w w w . d e l l . c o m | s u p p o r t . d e l l . c o mDefaults Not enabled.Command Modes INTERFACECommandHistoryUsageInformationYou can assign one ACL (standard or extended ACL) to an interface.When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs andsoft-forwarded, if required, in the following scenarios:• on a Layer 2 interface - if a Layer 3 ACL is applied to the interface.• on a Layer 3 port or on a Layer 2/Layer 3 portRelatedCommandsshow ip access-listsDisplay all of the IP ACLs configured in the system, whether or not they are applied to an interface,and the count of matches/mismatches against each ACL entry displayed.Syntax show ip access-lists [access-list-name] [interface interface] [in]ParametersCommand Modes EXEC PrivilegeCommandHistory\implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action ofthe ACL from implicit-deny to implicit-permit (that is, if the traffic does notmatch the filters in the ACL, the traffic is permitted instead of dropped).vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the ID numbers of theVLANs.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO ModuleNote: This command is not supported on the MXL Switch loopback interfaces.ip access-list standard Configures a standard ACL.ip access-list extended Configures an extended ACL.access-list-name Enter the name of a configured MAC ACL, up to 140 characters.interface interface Enter the keyword interface followed by the one of the following keywordsand slot/port or number information:• For a Port Channel interface, enter the keyword port-channel followedby a number:Range: 1 to 128• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigEfollowed by the slot/port information.in Identify whether ACL is applied on ingress side.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
