318 | IPv4 Routingw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Example Figure 15-20. show ip route summary Command ExampleRelatedCommandsshow ip trafficView IP, ICMP, UDP, TCP, and ARP traffic statistics.Syntax show ip trafficCommand Modes EXEC PrivilegeCommandHistoryTable 15-10. show ip route summary Column HeadingsColumn Heading DescriptionRoute Source Identifies how the route is configured in FTOS.Active Routes Identifies the best route if a route is learned from two protocol sources.Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If thebest route or active route goes down, the non-active route will become the best route.ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, theninformation on those routes is displayed.Total 1388 active... Displays the number of active and non-active routes and the memory usage of thoseroutes.If there are no routes configured in the FTOS, this line does not appear.FTOS>show ip route summaryRoute Source Active Routes Non-active Routesconnected 17 0static 3 0ospf 100 1368 2Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5Total 1388 2Total 1388 active route(s) using 222440 bytesTotal 2 non-active route(s) using 128 bytesFTOS>show ip route Displays information about the routes found in switch.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module