Rapid Spanning Tree Protocol (RSTP) | 523Command Modes CONFIGURATION RSTP (conf-rstp)CommandHistoryRelatedCommandsedge-port bpdufilter defaultEnable BPDU Filter globally to filter transmission of BPDU on port fast enabled interfaces.Syntax edge-port bpdufilter defaultTo disable global bpdu filter default, use the no edge-port bpdufilter default command.Defaults DisabledCommand Modes CONFIGURATION (conf-rstp)CommandHistoryprotocol spanning-tree rstpEnter the RSTP mode to configure RSTP.Syntax protocol spanning-tree rstpTo exit the RSTP mode, use the exit command.Defaults Not configuredCommand Modes CONFIGURATION RSTP (conf-rstp)CommandHistoryExample Figure 28-2. protocol spanning-tree rstp Command ExampleUsageInformationRSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the nodescription command from RSTP mode.RelatedCommandsVersion 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Modulemax-age Changes the wait time before RSTP transitions to the Forwarding state.hello-time Changes the time interval between BPDUs.Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO ModuleVersion 8.3.16.1 Introduced on MXL 10/40GbE Switch IO ModuleFTOS(conf)#protocol spanning-tree rstpFTOS(conf-rstp)##no disabledescription Disable RSTP globally on the system.