Parameters86 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.comDrives Control, continuedPNU IDAccessRUN Value/Range DescriptionFactory Setting(P1.3)P6.15 184 — Keypad frequency reference (REF) 0.00–P6.4–P6.4 Hz The setpoint value (REF) defined here can be activated atparameter P6.2 and via the keypad (LOC/REM)In KEYPAD mode, the value can be changed with the arrowbuttons. The changes are written back automatically to thisparameter (P6.15)P6.16 1474 — Stop button active 1In the default settings, the STOP button of the keypad isactive in all operating modesThe Stop function can be set at parameter P6.80 No (deactivated)Stop executed only via control signal terminals (I/O) orfieldbus (BUS)Switching the LOC/REM button to KEYPAD removes theblock on the STOP button function set hereNote: This does not deactivate the Reset function (FSloading with 5s actuation of the STOP button)1 Yes (activated)P6.17 1427 X — Secondary remote control source 3Assignment of the control levels as at P6.1Control level 2 is activated via parameter P3.25P6.18 1428 X — Secondary remote speed reference 2Assignment of setpoint sources as at P6.2Setpoint source 2 is activated via parameter P3.26P6.19 502 — Secondary acceleration time (acc2) 10.00.1–3000s See Note 1 of parameter P6.5The activation is executed via parameter P3.15P6.20 503 — Secondary deceleration time (dec2) 10.00.1–3000s See Note 1 of parameter P6.6The activation is executed via parameter P3.15P6.21 526 X — Acceleration transition frequency (acc1–acc2) 0.000.00–P6.4 Hz 0.00 Hz = deactivatedIf the output frequency set here is exceeded, theacceleration time is switched automatically from acc1 (P6.5)to acc2 (P6.19)P6.22 1334 X — Deceleration transition frequency (dec1–dec2) 0.000.00–P6.4 Hz 0.00 Hz = deactivatedIf the output frequency set here is exceeded, thedeceleration time is switched automatically from dec1 (P6.6)to dec2 (P6.20)P6.23 1429 X — REV blocked 0The rotating field reversal of the output frequency is blocked0 Deactivated1 Activated
