ParametersM-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com 79Digital Outputs, continuedPNU IDAccessRUN Value/Range DescriptionFactory Setting(P1.3)P5.1 313 13 Overtemperature signal 214 Overcurrent control active15 Overvoltage control active16 PLC sequence control active17 PLC sequence control, single step completed18 PLC sequence control, program cycle completed19 PLC sequence control, pause20 Counter, value 1 reached. The counter value is the triggervalue set at P3.21 and can be reset by activating P3.2421 Counter, value 2 reached. The counter value is the triggervalue set at P3.22 and can be reset by activating P3.2422 RUN message active23 Analog minimum reference errorMessage if the setpoint signal (life zero) of AI1 and/or AI2 isbelow 4 mA- or 2V (P2.1 = 1, P2.5 = 1)24 LOG function fulfilledMessage if the logical operation of P13.3 is fulfilled (LOG = 1)25 PID controller, actual value monitoringMessage if the actual value is within the hysteresis set at P9.15and P9.1626 External brake actuatedSwitch threshold: set value of P12.827 Current monitoringSwitch threshold: set value of P5.828 Fieldbus, remote outputThe assigned digital output is written directly to the generalcontrol word (ID 2001, bit 13)P5.2 314 — RO2 signal (relay output 2) 3Like P5.1 Assignment of the functionP5.3 312 — DO Signal (Digital Output) 1Like P5.1 Assignment of the functionP5.4 315 — Frequency monitoring 1 0Monitoring of the selected frequency rangeActuate output if frequency is below or above Frequencymonitoring 1 reference value defined by P5.5.A monitoring message can be implemented via the digitaloutputs (P5.1, P5.2, P5.3 = 10)0 Deactivated1 0.00–P5.5 Hz frequency is below reference P5.52 P5.5–P6.4 Hz frequency is above reference P5.5(P6.4 = maximum frequency)
