Operation54 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.comStart-Stop Command with Maximum Setpoint ValueVoltage, Acceleration Ramp 3sAs an alternative (OR) to operation via control signalterminals, you can also operate the frequency inverterwithout connecting the control signal terminals by simplyswitching the control level and the setpoint value input.The following brief instructions indicate the required steps.Brief InstructionsThe brief instructions (see the figure on Page 55) provide agraphical description of the few steps necessary up to themotor start.● The frequency inverter carries out a self-test when thesupply voltage is applied. The backlight of the LCD displayis switched on and all segments are briefly actuatedWhen the MMX is switched on for the first time, it activatesthe Quickstart Wizard to guide you step-by-step through thedrive parameters (alternating display of P1.1 = 1).First read “Parameters” starting on Page 60.You can access the parameters when P1.1 = 0. Pressing[BACK/RESET] [ ] [OK] leads you to the operating datadisplay MON. This is always displayed after the power supplyis switched off.The frequency inverter is ready to start when there is analternating display M1.1 0.00 Hz.● The frequency inverter is now ready for operation, and isfactory set for activation and frequency setting via thecontrol signal terminals (I/0). The STOP button is active inthis modeChanges are only possible when there is flashing at the entrydigit (press OK button).● The direction can be changed via the two arrow buttons(< or >, cursor)● The drive is factory set to stop at 0 Hz and can then be runin the opposite direction by pressing the START button.Parameter P6.14 = 0 must be set in order to changedirection without a stopThe STOP function can be set via P6.8:● Free coasting● Deceleration rampLOC/REM buttonLOC = local, keypad (KEYPAD)REM = remote (I/0, BUS)ttfmax ~ n maxfP6.5 = 3s P6.8 = 0FWDREV+24V= 50 Hz0P6.4RUN STOP1LOCREMPressing the OK button allows you to change thealternating mode of the displayed value M1.1.The KEYPAD control level can be activated via theLOC/REM button. The menu level ( ) moves toREF and the displayed value switches to 0.00 Hz(default settings).Pressing the OK button activates the setpoint entry.The right-hand digit of the displayed 0.00 Hzflashes.Use these two arrow buttons to select theentry digit (cursor).Use these two arrow buttons to changethe frequency values (frequency set value).Press the START button to start (RUN) the drive inthe selected direction (default settings FWD).In the default settings, the STOP button is active inall operating modes.OKLOCREMOKI
