ParametersM-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com 65Quickstart WizardThe quick start assistant guides you in the quickconfiguration through all important settings that have to bemade or that you should check for your application (see A infigure on Page 64). The parameters that are called during theprocess are listed in the table on Page 66, in the “Basic(Standard Drive)” column.The process is run from parameter to parameter. Returning isnot possible here.When the quick configuration is completed, the frequencydisplay M1.1 is activated automatically. Selecting the PARmain menu again enables you to call up the parameters ofthe quick configuration and then change them freely.Besides the parameters of the quick configuration, systemparameters S1.1 to S4.3 are also shown after the firstsetting.P1.1 = 0 activates access to all parameters and the fullfunctionality of all buttons of the keypad (free parameterdefinition, see B in the figure on Page 64).This exits the quick configuration and the guided setup withthe quick start assistant.In the quick configuration, the OK button activatesthe individual parameter values and then moves onto the next parameter. Every parameter alwaysshows the value that is set in alternating sequence.By actuating the OK button again, you activate thevalue (value flashes).The arrow buttons have restrictedfunctionality (change of parameter valuesand cursor control) in the quick startconfiguration.OK
