Parameters130 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.comSetpoint Input (REF), continuedSequence Commands Display Description3 If the supply voltage is switched on with the KEYPAD controllevel set, the MON menu item is activated first. The set displayvalue is shown in automatic alternation (factory setting: M.1.10.00 Hz)Actuate the BACK/RESET, and OK buttons in succession. The entrylevel is then reactivated (see sequence 2)4 The two arrow buttons (< or >) are used to change the rotatingdirection (FWD, REV)FWDREVThe rotating direction change is carried out in the factory setting(P6.14 = 0) with an automatic stop at 0 Hz. For a direct changeover(FWD/REV) you must set parameter P6.14 = 1Note: The frequency of the REV rotating field direction is notdisplayed with a negative signNote: When the setpoint entry is active (flashing number display), thearrow buttons are used to change the entry locations (cursor)RUN STOP ALARM FAULTREADYREFFWD REV I/O KEYPAD BUSMONPARFLTDisplay in AutomaticRUN STOP ALARM FAULTREADYREFFWD REV I/O KEYPAD BUSMONPARFLTBACKRESETOKRUN STOP ALARM FAULTREADYREFFWD REV I/O KEYPAD BUSMONPARFLTRUN STOP ALARM FAULTREADYREFFWD REV I/O KEYPAD BUSMONPARFLT
