Parameters64 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.comParameter Menu (PAR)You have access to all M-Max parameters in the parametermenu (PAR) (see “List of Parameters” on Page 161).Parameter Menu (P1.1 = 1, Quick Configuration)The parameter menu always starts with the parameter P1.1.P1.1 = 1 means that you are guided through the parametersby the Quickstart Wizard. Here you must confirm a specifiednumber of parameters individually (see A).P1.1 = 0 gives you free access to all parameters (see B).Schematic Representation of Parameter AccessDisplay in Automatic AlternationRUN STOP ALARM FAULTREADYREFFWD REV I/O KEYPAD BUSMONPARFLTRUN STOP ALARM FAULTREADYREFFWD REV I/O KEYPAD BUSMONPARFLTItemNumber DescriptionA Guided access and selected parameters with the QuickstartWizard (use OK button to move further)B Free access to all parameters (move further using the fourarrow buttons)1 Parameter conceal selectionP1.1 = 1 (Factory setting)The quick start assistant guides you to the selected parameters(predefined parameter change)P1.1 = 0 allows access to all parameters (free parameter selection)2 Selection of pre-defined parameter values for various applications(see table on Page 66)P1.2 = 0: Basic, no preliminary settingP1.2 = 1: Pump driveP1.2 = 2: Fan driveP1.2 = 3: Feed unit (high load)3 Completion of the quick configuration and automatic switch tofrequency displaySelecting the PAR menu level again allows the free selection ofthe required quick configuration parameters and the systemparameter (S)4 Free selection of all parameters (P1.1 = 0) with the two arrowbuttons and or < and >P1.1 = 1P1.2 = 0P1.2 = 1P1.2 = 2P1.2 = 3P1.3P11.7M1.1A321 P1.1 = 0P1.1 = 0P1.2 = 1P1.2 = 2P1.2 = 3P1.3S4.3P14.16S1.1B124
