Appendix AM-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com 155MMX-NET-XBThe MMX-NET-XB interface module enables the flushmounting and connection of fieldbus interface cards to thefrequency inverters in frame sizes FS4 and FS5.MMX-NET-XB Interface ModuleNote: The MMX-NET-XB interface module is not suppliedwith the M-Max frequency inverter.Note: Detailed installation instructions are provided inIL04012010Z.The MMX-NET-XC interface module is fitted under the coveron the right-hand side (view from front of the keypad) of theMMX frequency inverter:● First remove the cover of the frequency inverter (4 screws)Remove Cover (FS4, FS5)Accessories are provided with the MMX-NET-XB for fittingthe fieldbus interface card and interface module.Mounting Accessories for FS4, FS5● To install, remove the screw in the bottom right corner ofthe frequency inverter (chassis connection, board)● Then fit the metal bracket marked 04 (= FS4) or 05 (= FS5)with this screw● At the top end of the metal bracket fasten the two metalclipsThe fieldbus interface cards with pluggable screw terminalsmust be plugged in to support the terminals of the plasticstrip.Plastic Bridge for Holding the Control Terminals(For example: OPTE3 0 XMX-NET-PS-A)● Then connect the required fieldbus interface card to theMMX-NET-XB interface moduleT x 2004 = MMX, FS405 = MMX, FS51 x 1 x2 x1 xOPTE3
