CHAPTER 6: ACTUAL VALUES469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 6–36.1.2 DescriptionMeasured values, maintenance and fault analysis information are accessed in ActualValue mode. Actual values may be accessed via one of the following methods:1. The front panel, using the keys and display.2. The front program port and a portable computer running the EnerVista 469Setup software supplied with the relay.3. The rear RS485 port and a PLC/SCADA system running user-written software.Any of these methods can be used to view the same information. A computer makesviewing much more convenient, since many variables may be viewed at the same time.Actual value messages are organized into logical groups, or pages, for easy reference. Allactual value messages are illustrated and described in blocks throughout this chapter. Allvalues shown in these message illustrations assume that no inputs (besides control power)are connected to the 469.In addition to the actual value messages, there are also diagnostic messages and flashmessages that appear when certain conditions occur. Diagnostic messages are describedon page –37. Flash messages are described on page –38.MESSAGE EVENT256 [Z] See page –33.MESSAGE END OF PAGE ACTUALVALUES [Z] 469MODEL [Z] See page –36.MESSAGE CALIBRATION [ See page –36.MESSAGE END OF PAGE
