CHAPTER 6: ACTUAL VALUES469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 6–29The values in this menu reflect the RTD names as programmed If no RTDs are programmedin S8 RTD TEMPERATURE, the THIS FEATURE NOT PROGRAMMED flash message willappear when an attempt is made to enter this group of messages.6.4.4 Analog Input Min/MaxPATH: ACTUAL VALUES ZV A3 LEARNED DATA ZV ANALOG IN MIN/MAXThe 469 will learn the minimum and maximum values of the analog inputs since they werelast cleared. This information can be cleared with the S1 469 SETUP ZV CLEAR DATA ZVCLEAR ANALOG I/P MIN/MAX settings. When the data is cleared, the present value of eachanalog input will be loaded as a starting point for both minimum and maximum. The nameof the input and the units will reflect those programmed for each input.The values shown here reflect the programmed analog input names. If no Analog Inputsare programmed in S12 ANALOG I/O, the THIS FEATURE NOT PROGRAMMED flashmessage appears when an attempt is made to enter this group of messages. ANALOGINPUT [Z]MIN/MAXANALOG I/P 1MIN: O UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 1MAX: 0 UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 2MIN: O UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 2MAX: 0 UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 3MIN: O UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 3MAX: 0 UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 4MIN: O UnitsRange: –50000 to 50000MESSAGE ANALOG I/P 4MAX: 0 UnitsRange: –50000 to 50000
