Service Processor CheckpointsService processor checkpoints are in the range 8xxx to Bxxx. The message OK indicates successfulservice processor testing and initialization. Firmware checkpoints are listed in “Firmware Checkpoints” onpage 140.Note: A spinning (or twirling) slash displays in the upper-right corner of the operator panel display whilesome checkpoints are being displayed. If the slash stops spinning, a hang condition is indicated.Table 1. Service Processor CheckpointsCheckpoint Description Action/Possible Failing FRU8000 Test of the service processor DRAM See note 1 on page 138.8004 Verify base code checksum See note 1 on page 138.8008 Verify base code mirror checksum See note 1 on page 138.8009 Set NVRAM configuration in TITAN See note 1 on page 138.800F Start base code See note 1 on page 138.8010 Start supervisor in base code See note 1 on page 138.8012 Initialize hardware interrupts See note 1 on page 138.8014 Allocate and initialize area in DRAM See note 1 on page 138.8016 Initialize debugger and build VPD See note 1 on page 138.8018 Initialize service processor interfaces See note 1 on page 138.801A Initialize external FLASH load See note 1 on page 138.801B Initialize and test ISA hub chip See note 1 on page 138.801C Initialize and test SUPER I/O chip See note 1 on page 138.801F Initialize diskette, verify VDASD and startoperational loaderSee note 1 on page 138.809x Related to recovery mode system firmwareupdate from disketteSee note 3 on page 138.8092 Diskette initialization during recovery modesystem firmware updateSee note 3 on page 138.8098 Firmware image being read during recoverymode system firmware updateSee note 3 on page 138.809C Firmware image being written duringrecovery mode system firmware updateSee note 3 on page 138.809F Diskette error during recovery mode systemfirmware updateSee note 3 on page 138.8100 Start operational loader See note 1 on page 138.81xx Load code into DRAM from VDASD (wherexx = number of loads)See note 1 on page 138.81FE Load service processor operating system See note 1 on page 138.81FF Start service processor operating system See note 1 on page 138.9000 Primary service processor task initializing See note 1 on page 138.9009 System processor IPL has started See note 1 on page 138.9010 Primary service processor thread waitingfor responseSee note 1 on page 138.9020 Service processor state set to pre-standby See note 1 on page 138.Chapter 4. Checkpoints 133
