Operator Panel Component LocationsThe following illustration shows the component location on the operator panel.Number Component Name Component Description1 Operator Panel Display Displays current status of system startup, or diagnosticinformation in the event of a hardware problem.2 Front Serial Connector (FS1)(Model 6C3 Only)Serial port uses RJ-45 connector. Use to plug in externaldevices at the front of the system unit.3 Attention LED Normal State - LED is off4 System Reset Button Resets the system5 Power LED Blinking - When connected to the power source (System isin standby mode).Solid - When power-on button has been pressed.Note: There is approximately a 30-second transition periodfrom the time the power-on button is pressed to when thepower LED goes from blinking to on solid. During thetransition period, you may observe the blinking intervalsspeed up.6 Power-On Button Turns the system power on and off.7 Service Processor Reset Switch(Pinhole)Service Personnel Use8 Serial Number Label Displays the system serial numberChapter 1. Reference Information 19
