Setup Remote IPL (Initial Program Load)This option allows you to enable and set up the remote startup capability of your system. A list of NIC(network interface card) adapters in the system displays first. The following is an example of this screen.NIC AdaptersDevice Slot Hardware Address1. 10/100 Mbps Ethernet PCI Adapt Integ: U0.1-P1/E1 00096baeac102. IBM 10/100/1000 Base-TX PCI Integ: U0.1-P1/E2 0009cbce0fde-------------------------------------------------------------------------------------------Navigation keys:M = return to main menuESC key = return to previous screen X = eXit System Management Services-------------------------------------------------------------------------------------------Type the number of the menu item and press Enter or Select a Navigation key: _When an adapter is selected, the network parameters menu displays:Network Parameters10/100 Mbps Ethernet PCI Adapter II: U0.1-P1/E11. IP Parameters2. Adapter Parameters3. Ping Test-------------------------------------------------------------------------------------------Navigation keys:M = return to main menuESC key = return to previous screen X = eXit System Management Services-------------------------------------------------------------------------------------------Type the number of the menu item and press Enter or Select a Navigation key: _Selecting the IP (Internet Protocol) parameters option displays the following menu:IP Parameters10/100 Mbps Ethernet PCI Adapter II: U0.1-P1/E11. Client IP Address [000.000.000.000]2. Server IP Address [000.000.000.000]3. Gateway IP Address [000.000.000.000]4. Subnet Mask [255.255.255.000]-------------------------------------------------------------------------------------------Navigation keys:M = return to main menuESC key = return to previous screen X = eXit System Management Services-------------------------------------------------------------------------------------------Type the number of the menu item and press Enter or Select a Navigation key: _To change IP parameters, type the number of the parameters for which you want to change the value.Entering IP parameters on this screen will automatically update the parameters on the ping test screen.Attention: If the client system and the server are on the same subnet, set the gateway IP address to[0.0.0.0].Selecting Adapter Configuration allows the setting of the network speed, enabling or disabling spanningtree, and setting the protocol as shown in the following example menu :Chapter 8. Using System Management Services 269
