Appendix F. General Attributes Required When Using a TTYTerminalThe following general attributes are the default settings for the diagnostic programs. Be sure your terminalis set to these attributes.Note: Set these attributes before the diagnostic programs are loaded.General Setup Attributes3151/11/31/41Settings3151 /51/61Settings3161 /3164Settings DescriptionMachine mode 3151 3151 PC 3161 or 3164 The diagnostic programs are set toemulate use of the 3161 ASCII DisplayTerminal. If your terminal can emulate a5085, 3161 or 3164 terminal, use theseattribute settings. Otherwise, refer to youroperator’s manual, compare the attributedescriptions with those of your terminal,and set your attributes accordingly.Generated Code Set ASCIIScreen Normal Normal Uses the EIA-232 interface protocol.Row and Column 24 x 80 24 x 80 Uses the EIA-232 interface protocol.Scroll Jump Jump Jump When the last character on the bottomline is entered, the screen moves downone line.Auto LF Off Off Off For the ″On″ setting, pressing the Returnkey moves the cursor to the firstcharacter position of the next line. For the″Off″ setting, pressing the Return keymoves the cursor to the first characterposition of the current line. The CR andLF characters are generated by the Newline setting.CRT saver Off Off 10 The ″10″ setting causes the displayscreen to go blank if there is no activityfor 10 minutes. When the system unitsends data or a key is pressed, thescreen contents display again.Line wrap On On On The cursor moves to the first characterposition of the next line in the page afterit reaches the last character position ofthe current line in the page.Forcing insert Off OffTab Field Field Field The column tab stops are ignored, andthe tab operation depends on the fieldattribute character positions.Trace All Both inbound data (data to the systemunit) and outbound data (data from thesystem unit) to and from the main portcan be transferred to the auxiliary portwithout disturbing communications withthe system unit when the Trace key ispressed.429
