24. Select Install/Configure Devices Added After IPL and press Enter. Follow the instructions on thescreen. Successful replacement is indicated by the OK message displayed next to the Command fieldat the top of the screen.Do not use Install/Configure Devices Added After IPL if your system is set up to run HACMPclustering. To determine the correct method to configure the replacement device, consult with yoursystem administrator or software support.Accessing the PCI Hot-Swap ManagerThe installation instructions for hot-pluggable PCI adapters refer you to these procedures when it isappropriate to perform them.Attention: The Linux operating system does not support these hot-pluggable procedures. Also, Linuxdoes not support hot-swapping any hot-pluggable PCI adapters. The system with Linux installed must beshut down and powered off before replacing any PCI adapter. Follow the non-hot-pluggable adapterprocedures when replacing a PCI adapter in a system with the Linux operating system installed.Note: A PCI adapter is only hot-pluggable if the PCI adapter is supported for hot-swap applications. Seethe RS/6000 & pSeries PCI Adapter Placement Reference, order number SA38-0538, for completeinformation regarding your PCI adapter.Accessing PCI Hot-Swap Management FunctionsNote: Removing or installing a hot-pluggable PCI adapter requires the system administrator to take thePCI adapter offline prior to performing the operation. Before taking an adapter offline, the devicesattached to the adapter must be taken offline as well. This action prevents a service representativeor user from causing an unexpected outage for system users.For additional information about taking an adapter offline or removing it from the systemconfiguration, see the AIX System Management Guide: Operating System and Devices.Documentation for the AIX operating system is available from the IBM Eserver pSeries InformationCenter at http://publib16.boulder.ibm.com/pseries/en_US/infocenter/base. Select AIXdocumentation. The AIX Documentation CD contains the base set of publications for the operatingsystem, including system-management and end-user documentation.This publication is also contained on the AIX Documentation CD. The documentation is madeaccessible by loading the documentation CD onto the hard disk or by mounting the CD in theCD-ROM drive.To access the hot-swap manager menus, do the following:1. Log in as root user.2. At the command line, type smitty.3. Select Devices.4. Select PCI Hot Swap Manager and press Enter.5. The PCI Hot-Swap Manager menu displays. The following section describes the menu options.6. If you were directed here from a hot-swap procedure in this book, return to the procedure.Using the PCI Hot-Swap Manager MenuThe following options are available from the PCI Hot Swap Manager menu:Note: For information about the PCI slot LED states, see Chapter 12, “Component and Attention LEDs,”on page 389.List PCI Hot-Swap SlotsChapter 9. Removal and Replacement Procedures 307
