v Telephone Number Setup Menu, see “Telephone Number Setup Menu” on page 246.v Call-Out Policy Setup Menu, see “Call-Out Policy Setup Menu” on page 248.v Customer Account Setup Menu, see “Customer Account Setup Menu” on page 248.v Call-Out Test tests the configuration after the modem is installed and configured correctly.Modem Configuration MenuNote: This option applies only to a modem attached to serial port 1 (S1) or serial port 2 (S2) on the CECbackplane.The first two lines of the Modem Configuration Menu contain status of the current selections. Selectionsare made in the sections labeled Modem Ports and Modem Configuration File Name. Select the serial portthat you want to activate and then select the modem configuration file for the modem on the port. If youwant to set up all of the serial ports with modems, make your selections one port at a time.Modem Configuration MenuPort 1 Modem Configuration File Name:Port 2 Modem Configuration File Name:To make changes, First select the port and then the configuration filenameModem Ports:1. Serial port 12. Serial port 2Modem Configuration File Name:5. none9. modem_z_sp6. modem_f_sp 10. modem_m1_sp7. modem_f0_sp 11. modem_m0_sp8. modem_f1_sp 12. modem_m1_sp30. Save configuration to NVRAM and Configure modem98. Return to Previous Menu0>For information on choosing a modem configuration file, see “Sample Modem Configuration Files” on page433 and “Transfer of a Modem Session” on page 439.Serial Port Selection MenuThis menu allows you to enable or disable the call-in and call-out functions of each serial port in anycombination.Chapter 7. Using the Service Processor 245
