Model 6C3 Removal and Installation into a RackBefore performing these procedures, read “Safety Notices” on page xi.System Drawer RemovalCAUTION:This unit weighs between 32 kg (70.5 pounds) and 55 kg (121.2 pounds). Three persons arerequired to safely move it. Using fewer than three persons to move it can result in injury.CAUTION:v Removing the system drawer requires three people.v Do not place more than one drawer in the service position at one time.v Ensure that the system cables are not tangled and will not bind when placing the system drawerinto the service or operating positions.To remove the system drawer from the rack, do the following:1. If you have not already done so, shut down the system as described in “Stopping the System” onpage 282.2. Open the front and rear rack doors.3. Disconnect all cables from the rear of the system drawer.4. Disconnect the cable-management arm by pulling out the two captive snap buttons from the rear ofthe system drawer.5. From the front of the system drawer, lift the lower section of the system drawer release latches, whichare located on each side of the system drawer. The system drawer release latch clicks as it is putinto the release position.6. Grasp the top section of both latches, and slowly pull the system drawer out into the service position.7. Depress both safety release tabs located on each inner rail, and pull the system drawer outapproximately 2 inches.8. Put the system drawer into the service position.9. Using three persons, grasp the system drawer handles located on each side of the system.10. Depress the safety latches located on each rail.11. Remove the system by pulling it completely out and away from the rack and outer rack rails.12. Push the extended outer rails carefully back into the rack.Note: There is a gravity-activated locking tab at the back of each extended outer rail. The locking tablocks the outer rails into their fully extended position and is unlocked by the action of the innerrail being pushed back into the rack. To compensate for the separation of the inner rail fromthe outer rail, center the lock tab with your hand, then push the outer rail back into its retractedposition.13. Close the front and rear rack doors.Installing the Model 6C3 into the Rack EnclosureCAUTION:When installing this system drawer into a rack, ensure that a hazardous condition is not createddue to uneven mechanical loading. If your rack uses a stabilizer bar, it must be firmly attachedbefore installing or removing this system.To install the Model 6C3 onto a system rail assembly (type 2), do the following:414 EserverpSeries 615 Service Guide
