130 / User PreferencesModular ICS 4.0 System Coordinator Guide P0881591 Issue 01Use the display buttons to change the programming for abutton. User Preferences programming cannot change thebuttons that are used by lines, intercom, and the handsfreefeature.The display buttons used in button programming.Information about individual displays is described on page132.Changing User Speed Dial1. Press ≠ at User Speed Dial. The display showsthe number of speed dial codes that are available.2. Press ‘ to see the first speed dial code (71).3. Press ‘ to move through all the speed dial codes.4. Press ≠ at the code you want to change.5. Press CHANGE and enter the telephone number the sameway you would dial it on the telephone.6. Press OK.CANCL Moves you out of a setting without making any changes to it.CLR Erases the button.TEL# Programs the key as an autodial number for an internal or anexternal number. If it is an external autodial number, youmust choose a line, line pool, or the routing table for the callto use.CHANGE Used when you are setting up an external autodial number.Press CHANGE until you see the type of line or pool you wantthe number to use.FEATR Press to store a feature code on the button.FIND Locates a specific button on a telephone by entering itsnumber. Button numbers are shown in the illustrations.LIST Takes you to a list of feature codes. Press ‘ to movethrough the list and press OK when you see the feature youwant to program on the button.