Programming Hunt Groups / 143P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide6. Press ≠. The display shows Show group.7. Enter the Hunt Group number you want to program (1-30).8. Press ≠. The display shows Member DNs:.9. Press ‘ until the display shows If busy:.10. Press CHANGE to set the mode: BusyTone, Overflow,Queue.11. Press ® to exit or ‘ to continue programming.Programming the queue time-outThis setting allows you to program the number of seconds acall remains in the Hunt Group queue before it is routed to theoverflow position.1. Place the programming overlay on any M7310 or M7324telephone.2. Press ƒ••¤flfl‹›› (CONFIG).The display shows Password:.3. Press ‡¤‡fi°‡ (SCPLUS). The display showsTerminals&Sets.4. Press ‘ until the display shows Systemprgrming.5. Press ≠. The display shows Hunt groups.6. Press ≠. The display shows Show group.7. Enter the Hunt Group number you want to program (1-30).8. Press ≠. The display shows Member DNs:.9. Press ‘ until the display shows Q Timeout:.10. Press CHANGE to set the queue time-out: 15, 30, 45, 60,120, 180.11. Press ® to exit or ‘ to continue programming.