Programming feature settings 135P0607114 Issue 01 Compact Plus System Administration GuidePark modePark mode allows you to suspend a call. The call can then beretrieved by entering a retrieval code at any Norstar/BSTextension in the system.The Park mode retrieval code is a three-digit number. By default,the first digit of that number is 1, with the possible retrieval codesranging from 101 to 109.Note: 109 is reserved for M7000/T7000 and M7100/T7100telephones.You can determine how the system will assign retrieval codes toall telephones, except the M7000/T7000 and M7100/T7100telephones, by choosing one of the following modes:Lowest—Norstar assigns the lowest available retrieval code. Ifthere is only one parked call on the system, the number is 101. Ifthere are three calls, they are assigned 101, 102, and 103.Cycle—Norstar assigns the next available retrieval code in thesequence (101 to 108). If the last parked call was assigned 106,then the next one is assigned 107. If the last retrieval code was108, then the next code is 101.See ‘Call Parking’ on page 250 for information on using thisfeature.1. Place the programming overlay over the appropriate keys onyour programming telephone.2. Press ≤••¤flfl‹›› (CONFIG). Thedisplay shows Password:.3. Press ‡¤‡fi°‡ (SAPLUS). The display showsTerminals&Extns.4. Press ‘ until the display shows System prgrming.5. Press ≠. The display shows Hunt groups.6. Press ‘ until the display shows Featr settings.7. Press ≠. The display shows Backgrnd music.8. Press ‘ until the display shows Park Mode:.9. Press CHANGE to choose Lowest or Cycle.10. Press ® to exit or ‘ to continue programming.
