64 Setting System speed dialCompact Plus System Administration Guide P0607114 Issue 015. Press ≠. The display shows Speed dial#:.6. Enter the System speed dial code (001 to 255) you want touse.7. Press ‘ until the display shows Display digits:.8. Press CHANGE to choose N (No).No means the display shows a name for the code.9. Press ‘. The display shows Name: Sys spd di….Press ≠ to see the rest of the display.10. Press CHANGE. The display shows Name:.11. Enter the name you want to give to the speed dial code.Enter the name by pressing the appropriate key on the keypaduntil the first letter of the name is displayed. Press -->, thenenter the next letter of the name and so on until the name iscomplete. Up to 16 characters are allowed. Press # to addspaces.12. Press ® to exit or ‘ to continue programming.CLID name displayWhen you specify a name for a system speed dial, the systemdisplays the name programmed on that speed dial when youreceive a call from that number over a number-only analogue lineor target line. If you do not specify a name, then only the numberor line will appear for the call, depending on how the line wasprogrammed.Note: For name display to occur, the calling number must alsomatch the system speed dial entry, as defined under CLID match.Refer to "CLID Match" on page 144.To program which display appears first on your telephone, followthese steps:1. Place the programming overlay over the appropriate keys onyour programming telephone.2. Press ≤••¤flfl‹›› (CONFIG). Thedisplay shows Password:.3. Press ‡¤‡fi°‡ (SAPLUS). The display showsTerminals&Extns.4. Press ≠. The display shows Show extn#:.5. Enter the extension number of the telephone you want toprogramme. The display shows nnn:nnn.6. Press ≠. The display shows Line access.7. Press ‘ until the display shows Call Services.
