cm6520 2-65Basic copy operations 2Basic copy operations Chapter 2– When the "2 Position" Staple setting is selected.– When the "Corner" Staple setting is selected.– Touch [Auto] to automatically determine the stapling position according to the orientation of theloaded document. If the document length is 11-11/16 inch or less, the long side of the paper isstapled. If the document length is more than 11-11/16 inch, the short side of the paper is stapled.– If "Auto" is selected for the stapling position, load the document with the top toward the back of themachine. If the document is loaded in any other orientation, the stapling will not be correctlypositioned.– If "Auto" is selected, the stapling position is set at the top or at the left.– To cancel the setting and select the default, press the [Reset] key.4 If desired, touch [Original Direction], and then select the setting appropriate for the document.– For details on specifying the document orientation, refer to "Selecting the document orientation(Original Direction settings)" on page 2-21.5 Touch [OK].The Basic screen appears again.
