11 Utility mode11-52 cm65203 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [3 Finisher Adjustment].The Finisher Adjustment screen appears.5 Touch [6 Punch Horizontal Position Adjustment].The Punch Horizontal Position Adjustment screen appears.6 Check the horizontal position of the punched holes.– To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).– Each time [+] or [-] is touched, the value is increased or decreased by one increment.– To decrease width A, touch [-] to decrease the adjustment (between -0.1 mm and -5.0 mm).7 Touch [OK].– To cancel the setting and select the default, press the [Reset] key.The horizontal position of the punched holes is adjusted.If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completesthe procedure.8 Use a Punch setting to print another sample copy.AA
