cm6520 11-43Utility mode 11Utility mode Chapter 116 Touch the button for the paper tray to be set.7 Press the [Start] key.A test pattern is printed.8 Check that the distance from the starting print position of the test pattern to the edge of the paper (d)is 3 mm (±0.5 mm).– If the distance is 2.4 mm or less, touch [+] to increase the adjustment (between 0.2 mm and 3.0 mm).– If the distance is 3.6 mm or more, touch [-] to reduce the adjustment (between -0.2 mm and -3.0mm).– If the distance is between 2.5 and 3.5 mm, continue with step 10.– Each time [+] or [-] is touched, the value is increased or decreased by one increment.9 Press the [Start] key.The adjusted test pattern is printed.10 Adjust the distance from the starting print position of the test pattern to the edge of the paper.– Check that the distance has been adjusted to between 2.5 and 3.5 mm.– If more adjustment is necessary, repeat steps 8 and 9.– To adjust the print position for a different paper tray, return to step 6.11 Touch [OK].– To cancel the setting and select the default, press the [Reset] key.The print position is adjusted.2 NoteSet the value by mm. Refer to the conversion rate below. 1 in. = 25.4 mmdd: 3.0 mm ± 0.5 mm
