7 Application functions7-80 cm6520– The setting for "Page Number" can be set to a number between –99999 and 99999, and the settingfor "Chapter" can be set to a number between –100 and 100.– When specifying a setting for "Starting Page Number", switch the number between positive andnegative by pressing the [ ] key.– If a negative value is specified, the numbers are not printed until the numbering reaches 1. Forexample, if "–1" was specified, the numbers are printed starting with "1" on the third copied page.– To cancel the "Page Number" function, touch [No].5 Select a setting under "Page Number Type".6 Touch [Print Position], and then select the printing position.– To make fine adjustments to the printing position, touch [Adjust Position]. Select the desireddirection under "Left & Right Adjustment" or "Top & Bottom Adjustment", touch [↔] to switchbetween the integer and the fraction, touch [–] and [+] to specify the adjustment amount, and thentouch [OK].– If a decimal value is displayed in the screen, press the [C] (clear) key, and then use the keypad totype in the adjustment amount. For details on switching between decimal and fraction values, referto "System Settings" on page 11-13.– If a decimal value is displayed in the screen and the specified value is outside the allowable range,the message "Input Error" appears.Type a value within the allowable range. If the value was incorrectly entered, press the [C] (clear) keyto erase the value, and then specify the correct value.? What are the limits on the adjustment amount?% The print position can be finely adjusted in 1/16 inch increments.? Can no adjustment be made?% To make no left/right or up/down adjustments, touch [No Adjustment].
