Panasonic EYFR03 User Manual

Also see for EYFR03: Training guide

EYFR03 User Manual 52 of 110 v1.6.0Chapter 4: 20 January 2020VIN SelectionsStarting with version 1.2.5, you may configure the EYFR03 to use VIN barcode scans to select aparameter, group, or job. The selections must be configured via the Assembly Managerprogram.Both the Atlas Copco Open Protocol and EtherNet/IPTM can provide a VIN to the EYFR03.VINs received from these protocols will still be placed in the VIN field, but they are ignored bythe VIN selection feature. If a network is able to provide VINs, it is expected that the networkwill also control the selection of operations through one of the mechanisms provided in thatprotocol.SettingsNo match behaviorDefault: ContinueValues: Continue, Stop, IgnoreThis setting determines what happens when a selector scan does not match one of the VINselections.When set to Continue, the EYFR03 will store the scan in its Selector field, but will not stop orchange the running operation for a non-matching scan.When set to Stop, the EYFR03 will discard the scan and blank both the Selector and VIN fieldsand will stop the running operation for a non-matching scan.When set to Ignore, the EYFR03 will ignore any selector scans that do not match one of the VINselections and act as if the scan never occurred.Selection modeDefault: Single ScanValues: None, Single Scan, Dual Scan, VIN then Selector, Selector then VINThis setting determines the mode the EYFR03 uses for the VIN Selection feature. The modeswill be described in more detail in the next section.Second scan timeoutDefault: 5Range: 0-99 secondsThis setting determines how long the EYFR03 will wait for a second scan when using one of theselection modes requiring two scans. If a valid second scan is not received during the timeout,the EYFR03 will discard the first scan, and if No match behavior is Stop, will also stop therunning operation.VIN lengthDefault: Variable