Panasonic PT-EX12KU Operating Instructions Manual

Also see for PT-EX12KE: Operating instructions

Contents

Using the remote control24 - ENGLISHPreparationUsing the remote controlInserting and removing the batteries1) Open the cover.(ii)(i)2) Insert the batteries and close thecover.■z Insert the side first.■z To remove the batteries, perform the aboveprocedure in the reverse order.Setting remote control numbersWhen you are using multiple projectors, you can set a remote control number to each projector to allowsimultaneous control with a single remote control.After setting a remote control number to the projector, specify the same remote control number to the remotecontrol.■■ Setting method1) While holding the button, press the number (<0> - <9>) buttons (2 digits) toenter the desired remote control number.■z When you release your finger, the remote control number will change to the new number.■z To set the remote control number to 09, press <0>, <9> while holding down the button.Note■z The factory default setting is [All]. [All] supports all remote control numbers.■z Set the remote control number of the projector using [Remote control] ( page 77) from the [Setting] menu.■z To reset the remote control number (to set to [All]), simultaneously hold down the button and the<0> button for at least five seconds.Using the remote control as a wired remote controlConnect the terminal on the projector body to the wired remote control terminal on the remotecontrol using the remote control cable (commercially available).■z Make sure that the batteries are inserted in the remote control.■z To use the remote control wirelessly, disconnect the remote control cable from the projector and the remotecontrol. When the remote control cable is connected, you cannot use the remote control wirelessly.