[Setting] menu70 - ENGLISHSettings[Background]Selects the background screen when there is no inputsignal.1) Press ▲▼ to select [Background].2) Press the button.3) Press ▲▼ to switch the setting.■z The setting will change as follows each timeyou press the button.[Blue] [User] *1 [Black]*1: Available when the image is registered.■z [User] displays the image registered by theuser.■z “Logo Transfer Software” is required to registerthe image.[Lamp select]Selects the lamp used for projection.1) Press ▲▼ to select [Lamp select].2) Press the button.■z The sub menu 2 is displayed.3) Press ▲▼ to select an item, and pressthe button.■z Press ◀ to return to the sub menu.[2-Lamps]Turns on two lamps.[1-Lamp][Auto]Automatically detects the lamp withthe shortest total time, and prioritizesto turn it on.Turns on lamp 1.Turns on lamp 2.4) Select [Yes], and press the button.■z The setting ends and the projector returns tothe sub menu 2 screen.■z Select [No] and press the button toreturn to the sub menu 2.Note■z If a lamp fails as a result of a fault or reaching theend of its service life, the lamp indicator REPLACE>/ on the front ofthe projector body. An X mark will also appear asthe lamp status at the top of the screen.■z When [2-Lamps] is selected and one lamp fails, theprojection will continue with one lamp.■z When [1-Lamp] is selected and one lamp fails,the lamp will be switched to the other one if it isavailable.■z If all the lamps fail, the power will switch off. If thepower is turned on without replacing the lampsafter the duration exceeds 2 200 hours of usagefor all lamps, the power automatically turns offafter approximately ten minutes to prevent themalfunction of the projector.[Lamp power]Sets switching of lamp brightness.Using the eco mode is recommended if you want toreduce power consumption.1) Press ▲▼ to select [Lamp power].2) Press the button.3) Press ▲▼ to switch the setting.■z The setting will change as follows each timeyou press the button.(Auto) Sets the brightness automaticallyusing a light-metering circuit.(Standard) Operates in certain brightness.(Eco mode 1)The projected image is darker than.(Eco mode 2)The air intake/exhaust increasesin comparison to , and the fanbecomes louder.