Powering on/offENGLISH - 43Basic OperationPowering on the projectorPowerbuttonPower ON> buttonControl panelRemote controlBefore turning on the power, remove the lens cover.1)Connect the power plug to the outlet.(AC 100 V - 240 V 50 Hz/60 Hz)2)Press theside of the main powerswitch to turn on the power.■zAfter a moment, the standby indicator will go on and the projector willenter the standby mode.3)Press the powerbutton on thecontrol panel or the power ON> button on the remote control.■zAfter a moment, an image will be projectedand the currently selected input signal andlamp status (page96) will be displayed forapproximately four seconds.Note■zWhen [PIN code lock] (page79) has been set to[On] using [Security] in the [Setting] menu, enteryour PIN code.■zThe projector will make a noise when the lampcomes on, but this is not a malfunction.■zDuring projection, the fan rotates, making a sound.The sound may change depending on the ambienttemperature, and when the lamp is on, the soundmay become loud.■zIf the lamp is switched off and immediately onagain, the newly projected image may wobblefor a few moments. This is due to the lampcharacteristics and is not a malfunction.■zWhen [Direct on] (page78) of the [Setting] menuis set to [On], the power will be turned on as soonas you insert the power plug into the outlet or setthe main power switch to theside.■zWhen [Display] (page69) of the [Setting] menuis set to [On] and [Logo] (page76) is set to [Off],the countdown will be displayed but the openingdisplay will not be displayed.■zWhen [Display] (page69) of the [Setting] menu isset to [Off] or [Countdown off], projection will startas soon as the lamp comes on, regardless of [Logoselect] (page76) setting.■zAfter turning on the power, notes on [Filter warning]and [Lamp replacement] may be displayeddepending on the status of the projector. (page97)Making adjustments andselectionsIt is recommended that the images are projectedcontinuously for at least 30 minutes before the focusis adjusted.4)Press the button to adjustthe focus of the image roughly.(page46)5)Press the to buttons on the remote control or the button on the control panelto select the input terminal. (page47)6)Adjust the projection angle. (page35)■zExtend the adjustable feet to adjust theprojection angle.7)Press the button toadjust the position of the image.(page45)8)Press the button to adjustthe size of the image to fit the screen.(page46)9)Press the button again toadjust the focus.10)Press the button again toadjust the zoom and the size of theimage to fit the screen.
