[Setting] menu76 - ENGLISHSettings[HDMI setup]If the image cannot be correctly displayed when anexternal device is connected to the projector usingHDMI, change the settings.1) Press ▲▼ to select [HDMI setup].2) Press the button.3) Press ▲▼ to switch the setting.[Normal] [Enhanced][Normal] Select when the output from theexternal device is “NORMAL *1 ”.[Enhanced] Select when the output from theexternal device is “ENHANCED *1 ”.*1: The titles of the output settings differ depending on thedevice. For details, refer to the operating instructions of theexternal device.[Logo]Sets logo selection and the PIN code for logoselection.1) Press ▲▼ to select [Logo].2) Press the button.■z The sub menu 2 is displayed.3) Press ▲▼ to select.■■ [Logo select]1) Select [Logo select], and press the button.2) Press ▲▼ to switch the setting.■z The setting will change as follows each timeyou press the button.[Off] [User] *1 [Default][Off] Clears logo from screen.[User] *1 Displays the image registered by theuser.[Default] Displays in the factory defaultsettings.*1: Available when the image is registered.■z “Logo Transfer Software” is required to registerthe image.■■ [Logo PIN code lock]Sets the system to make the setting and changingof the “logo” only by the administrator.1) Select [Logo PIN code lock], and pressthe button.■z The PIN code input screen is displayed.2) Press ▲▼◀▶ or the number (<0> -<9>) buttons to enter the PIN code.3) Press ▲▼◀▶ to select [Set].4) Press the button.■z If the PIN code is accepted, the projectorreturns to the sub menu 2.5) Press ▲▼ to switch the setting.[Off] [On][Off] The logo selection can be changedwithout the PIN code.[On] The PIN code is required to changethe logo selection.Note■z The entered PIN code is displayed with * mark onthe screen.■z The factory default setting for the logo PIN code is“4321”.■z To re-enter a number, press ◀▶ to select the digitto re-enter, then press ▲▼ or the number (<0> -<9>) buttons to re-select the number.■z Move the cursor to [Cancel] and press the button to return to the sub menu 2.■z If [Logo PIN code] and the number are displayed inred, an error has occurred. Re-enter the number.
