| 
About indicator statusENGLISH - 91 Maintenance■■ When there is a problem with the lampThe status of the indicator is displayed with the following symbols.s: Off, ●: On, H: Flashing, ■: On or FlashingIndicatorStatus of the projectorGreenRedTEMP.>RedFILTER>OrangeBlueREPLACE>/REPLACE>Orange■*1 ■*1 ■*1 ■*1 ■*1 H*2Either or both of the lamps do not turn on. (If bothof the lamps fail, they are cooling down. After thestandby indicator turns on again, pressthe power button on the remote controlor the power button on the control panel.)■*1 ■*1 ■*1 ■*1 ■*1 ●The recommended time to replace the lamp has beenreached.The will be displayed at the top right of the screento notify the user of replacement.Replace the lamp unit as soon as possible. Replacingthe lamp will cause the lamp indicator REPLACE>/ to turn off.*1: The indicator will turn on or flash under certain conditions, regardless of the status of other indicators.*2: The indicator will flash in approximately 1-second intervals.Note■z The status of each lamp can be checked as the lamp indicators /on the front of the projector turn on or flash. ( page 96)■■ When there is a problem with the shutterThe status of the indicator is displayed with the following symbols.s: Off, ●: On, H: Flashing, ■: On or FlashingIndicatorStatus of the projectorGreenRedTEMP.>RedFILTER>OrangeBlueREPLACE>/REPLACE>Orange■*1 ■*1 ■*1 ■*1 H*2 ■*1The shutter cannot be opened or closed. The lamp willturn off, cooling will begin and the projector will switchto the standby mode. The power will turn on and theprojector will attempt to open the shutter automaticallyup to three times. After three failed attempts, theprojector will switch to the standby mode after thelamp has cooled.s H*3 s s H*2 ■*1 There is a problem with opening or closing the shutter,and the lamp has turned off and is cooling down.s ● s ■*1 H*2 ■*1There is a problem with opening or closing the shutter,and projector will switch to the standby mode after thelamp has turned off and cooled down.*1: The indicator will turn on or flash under certain conditions, regardless of the status of other indicators.*2: The indicator will flash in approximately 0.5-second intervals.*3: The indicator will flash in approximately 1-second intervals.Note■z The status of each lamp can be checked as the lamp indicators /on the front of the projector turn on or flash. ( page 96) |
