[Setting] menu80 - ENGLISHSettings■■ [PIN code change]Changes the PIN code.1) Select [PIN code change], and pressthe button.■z The PIN code input screen is displayed.2) Press ▲▼◀▶ or the number (<0> -<9>) buttons to enter the PIN code.3) Press ▲▼◀▶ to select [Set].4) Press the button.■z If the PIN code is accepted, the new PIN codeis displayed on the screen.5) Press ▲▼◀▶ or the number (<0> -<9>) buttons to set your new PIN code.6) Press the button.7) Select [Yes], and press the button.■z If the PIN code is accepted, the projectorreturns to the sub menu 2.Note■z To re-enter a number, press ◀▶ to select the digitto re-enter, then press ▲▼ or the number (<0> -<9>) buttons to re-select the number.■z Move the cursor to [Cancel] and press the button to return to the sub menu 2.[Projector ID]Sets the projector ID (1 to 64) for the RS-232C serialcommunication.1) Press ▲▼ to select [Projector ID].2) Press the button.3) Press ▲▼ to switch the setting.■z The factory default setting is [All].[All]Makes projector accept operationsregardless of any ID numberspecified by the remote control orPC.[1] - [64] Sets ID numbers from 1 - 64 to theprojector.[Shutter]Sets the shutter function.1) Press ▲▼ to select [Shutter].2) Press the button.■z The sub menu 2 is displayed.3) Press ▲▼ to select.■■ [Protection]Locks the button to prevent shutter operations.1) Select [Protection], and press the button.2) Press ▲▼ to switch the setting.■z The setting will change as follows each timeyou press the button.Protection is off.Operation can be made from bothremote control and projector.Locks operations from the remotecontrol.Locks operations from the controlpanel.Locks operations from both theremote control and the control panel.