Panasonic PT-EX12KU Operating Instructions Manual

Also see for PT-EX12KE: Operating instructions

Contents

ProjectingENGLISH - 45 Basic OperationProjectingCheck the external device connections ( page 36) and power cord connections ( page 41) and then turn on thepower ( page 43) to start projection. Select the input signal and adjust the image.Selecting the input signalSelect an input signal.The images selected using the button on the control panel or the to buttons onthe remote control are projected. ( page 47)Attention■z Images may not be projected properly depending on the connected device, DVD, video tape, etc. to be played.■z The button on the control panel cannot be used to select input signals. The input signal for eachinput terminal must be selected in advance using the [Input] menu. If you press the button withouthaving correctly selected the input signal, the projector will not project the image correctly.Adjusting the image■■ Adjusting the position of the lens1) Press the button on the remote control or the control panel.■z [Lens shift] is displayed on the screen for four seconds.Lens shift2) While the display appears, press ▲▼◀▶ to move the image horizontally andvertically.■z As you move the image, there is a certain position at which the arrows pointing up, down, left and right turnred. This position is the center for the lens.■z At positions of maximum shift, the arrows disappear.■z The projector stores the setting made using the lens shift function when the power is turned off.■z When the position of the image is shifted, the image may become a little darker.* The figure below shows an example of when the standard lens is attached.With the lens moved completely upWith the lens moved completely downWith the lens moved completely tothe rightWith the lens moved completely tothe leftMoves the image upapprox. 50% of itsheight.Moves the imageleft approx. 10% ofits width.Moves the imageright approx. 10%of its width.Moves the imagedown approx. 50% ofits height.