|
[Setting] menu78 - ENGLISHSettings[Power management]1) Press ▲▼ to select [Powermanagement].2) Press the button.■z The sub menu 2 is displayed.3) Press ▲▼ to select an item, and pressthe button.[Off] Cancels power managementfunction.[Ready]Turns off the lamps and starts coolingwhen the time set using [Timer] haselapsed. While lamp is being cooled,the standby indicator ,and the power indicator are flashing, you cannot operate theprojector.When lamp cooling has finished, thepower indicator continuesflashing and the standby indicator lights up instead offlashing, indicating that the projectoris now in the power managementmode.From this point, if a signal is inputor operations are performed on theprojector, the lamps will turn on andthe projection will start.[Shut down]Turns off the lamps and starts coolingwhen the time set using [Timer] haselapsed. During lamp cooling, youcannot operate the projector.When lamp cooling has finished, thepower will turn off.[Timer] Sets times from 1 - 30 minutes.Note■z The factory default setting is [Off].■z The power management function cannot be usedwhen the freeze function ( page 47) or shutterfunction ( page 47) is in use.■z When the power management function is started,[P-timer] is reset.[Direct on]This is a function for automatically switching onthe power of the projector when the power cord isconnected, without requiring operations on the power button on the remote control or thepower button on the control panel.1) Press ▲▼ to select [Direct on].2) Press the button.3) Press ▲▼ to switch the setting.[Off] [On][Off] Enables normal operations to turnon/off the power.[On] Allows power to be turned ondirectly.Note■z Be sure to turn on/off the power using the correctoperations.■z Pressing the power button on theremote control or the power button on theprojector will not turn on the power until the lampcooling has finished and the lamps are ready to beturned on again. PreviousNext |