[Setting] menuENGLISH - 77 Settings■■ [Logo PIN code change]Changes the logo PIN code.1) Select [Logo PIN code change], andpress the button.■z The PIN code input screen is displayed.2) Press ▲▼◀▶ or the number (<0> -<9>) buttons to enter the PIN code.3) Press ▲▼◀▶ to select [Set].4) Press the button.■z If the PIN code is accepted, the new logo PINcode is displayed on the screen.5) Press ▲▼◀▶ or the number (<0> -<9>) buttons to set your new PIN code.6) Press the button.7) Select [Yes], and press the button.■z If the PIN code is accepted, the projectorreturns to the sub menu 2.Note■z To re-enter a number, press ◀▶ to select the digitto re-enter, then press ▲▼ or the number (<0> -<9>) buttons to re-select the number.■z Move the cursor to [Cancel] and press the button to return to the sub menu 2.[Fan control]The projector controls the rotation of the fanautomatically. You can make the rotation of the fanstronger depending on the ambient temperature orwhere the projector is installed (for example, when itis to be used at a high altitude).1) Press ▲▼ to select [Fan control].2) Press the button.3) Press ▲▼ to switch the setting.[Normal] [Max][Normal] Controls the fan operationautomatically.[Max]Forces the fan to work at maximumcapacity. Then sound of the fanrotating will be louder than with[Normal].[Remote control]Allows simultaneous control or individual control witha single remote control when multiple projectors areused side by side.1) Press ▲▼ to select [Remote control].2) Press the button.3) Press ▲▼ to select.■z The factory default setting is [All].[All] Makes projector accept input fromremote control of any ID number.[Code 01] -[Code 64] Sets ID numbers from 1 - 64.4) Press the button.5) Select [Yes], and press the button.■z [Remote control] will change.■z Returns the projector to the sub menu.Note■z When the ID number of the projector is changed,the ID number of remote control must be matchedto the ID number of the projector.■z If a projector is set to [All] with multiple projectors inuse, the projector cannot be controlled separatelyfrom the projectors with other ID numbers.[RC sensor]Enables and disables the remote control sensor onthe projector body.1) Press ▲▼ to select [RC sensor].2) Press the button.■z The sub menu 2 is displayed.3) Press ▲▼ to switch the setting.[Both] Enables all sensors on front or rearof the projector body.[Front] Enables only remote control sensoron front of the projector body.[Back] Enables only remote control sensoron rear of the projector body.
