Chapter 1 Preparation — Precautions for useENGLISH - 13Precautions for useCautions when transportingf When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. Doing so maydamage the internal components and result in malfunctions.f Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.Cautions when installingrDo not set up the projector outdoors.The projector is designed for indoor use only.rDo not set up the projector in the following locations.f Places where vibration and impacts occur such as in a car or vehicle: Doing so may cause damage to internal componentsor malfunction.f Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare cases dueto the hot air from the air exhaust port or the heated or cooled air. Make sure that the exhaust from the projector or otherequipment, or the air from the air conditioner does not blow toward the front of the projector.f Near lights (studio lamps, etc.) and other locations with severe temperature fluctuations (“Operating environment”(x page 123)): Placing the projector in these locations may result in malfunctions and the deformation of the outer case.f Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.f Place where there is high-power laser equipment: Directing a laser beam onto the lens surface causes damage to the DLPchips.rBe sure to ask a specialized technician or your dealer when installing the product to aceiling.The optional ceiling mount bracket is required.Model No.: ET-PKR100H (for high ceilings), ET-PKR100S (for low ceilings)rAsk a qualified technician or your dealer to install the cable wiring for DIGITAL LINKconnection.Image and sound may be disrupted if cable transmission characteristics can not be obtained due to inadequate installation.rThe projector may not work properly due to strong radiowave from the broadcaststation or the radio.If there is any facility or equipment, which outputs strong radiowave, near the installation location, install the projector at alocation sufficiently far from the source of the radiowave. Or, wrap the LAN cable connected to the terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.rLens focusThe high clarity projection lens is thermally affected by the light from the light source, making the focus unstable in the periodjust after switching on the power. Wait at least 30 minutes with the image projected before adjusting the lens focus.rDo not install the projector at elevations of 2 700 m (8 858') or higher above sea level.Doing so may shorten the life of the internal components and result in malfunctions.rDo not use the projector tilted to the right or left.Using the projector at a vertical angle that exceeds 15° may reduce product life or result in malfunction.rWhen installing and using the projector at an angle that exceeds 30° vertically, set[COOLING CONDITION] (x page 69).Failure to observe this will result in malfunctions or shorten the life of the internal components.