Chapter 4 Settings — [PROJECTOR SETUP] menu68 - ENGLISH[PROJECTOR SETUP] menuOn the menu screen, select [PROJECTOR SETUP] from the main menu, and select the itemfrom the sub-menu.Refer to “Navigating through the menu” (x page 40) for the operation of the menu screen.f After selecting the item, press asqw to set.[PROJECTOR ID]The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable simultaneouscontrol or individual control via one remote control.1) Press as to select [PROJECTOR ID].2) Press qw to switch [PROJECTOR ID].f The items will switch each time you press the button.[ALL] Set when controlling without specifying an ID number.[1] - [6] Set when specifying and controlling an individual ID number.Notef The ID number can be set to [ALL], or from [1] to [6].f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computercontrol.If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other IDnumbers.f Refer to “Setting the remote control ID numbers” (x page 21) regarding the method to set the ID number on the remote control.[PROJECTION METHOD]Set the projection method in accordance with the installation status of the projector.Change the projection method if the screen display is upside down or inverted.1) Press as to select [PROJECTION METHOD].2) Press the button.f The [PROJECTION METHOD] screen is displayed.3) Press as to select the projection method.[FRONT/FLOOR] When installing on the desk, etc., in front of the screen[FRONT/CEILING] When installing using the ceiling mount bracket (optional accessories) in front of the screen[REAR/FLOOR] When installing on the desk, etc., behind the screen (using a translucent screen)[REAR/CEILING] When installing using the ceiling mount bracket (optional accessories) behind the screen (using atranslucent screen)4) Press the button.5) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.Attentionf When [PROJECTION METHOD] is changed, confirm that [COOLING CONDITION] (x page 69) is set correctly.