Chapter 4 Settings — [NETWORK] menu98 - ENGLISH[E-mail set up] pageWhen there is a problem, an email can be sent to preset email addresses (up to two addresses).Click [Detailed set up] → [E-mail set up].1234561 [ENABLE]Select [Enable] to use the E-mail function.2 [SMTP SERVER NAME]Enter the IP address or the server name of the E-mail server(SMTP). To enter the server name, the setup of the DNS serveris required.3 [MAIL FROM]Enter the E-mail address of the projector. (Up to 63 charactersin single byte)4 [MEMO]Enter information such as the location of the projector thatnotifies the sender of the E-mail. (Up to 63 characters in singlebyte)5 [MINIMUM TIME]Change the minimum interval for the temperature warning mail.The default value is 60 minutes. In this case, another E-mailwill not be sent for 60 minutes after sending the temperaturewarning mail even if it reaches the warning temperature.6 [INTAKE AIR TEMPERATURE]Change the temperature setting for the temperature warningmail. A temperature warning mail is sent when the temperatureexceeds this value.877 [E-MAIL ADDRESS 1]Enter the E-mail address to be sent.8 Settings of the conditions to send E-mailSelect the conditions to send E-mail.[MAIL CONTENTS]:Select either [NORMAL] or [SIMPLE].[ERROR]:An E-mail message is sent when an error occurred in the self-diagnosis.[INTAKE AIR TEMPERATURE]:An E-mail message is sent when the air intake temperature hasreached the value set at the above field.[PERIODIC REPORT]:Place a check mark on this when E-mail is to be sentperiodically.It will be sent on the days and time with the check mark.
