Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 69[COOLING CONDITION]Change the fan control depending on the direction of projection.Set [COOLING CONDITION] correctly in accordance with the direction of projection referencing the following figure. Using the light source withincorrect settings may shorten its life.>9(57,&$/836(77,1*@>)/2256(77,1*@ >&(,/,1*6(77,1*@>9(57,&$/'2:16(77,1*@3URMHFWLRQGLUHFWLRQ1) Press as to select [COOLING CONDITION].2) Press the button.f The [COOLING CONDITION] screen is displayed.3) Press as to select a cooling condition.4) Press the button.5) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.[ECO MANAGEMENT]A function that optimizes the light source power to suit usage conditions to reduce power consumption.Setting [LIGHT POWER]1) Press as to select [ECO MANAGEMENT].2) Press the button.f The [ECO MANAGEMENT] screen is displayed.3) Press as to select [LIGHT POWER].4) Press qw to switch [LIGHT POWER].f The items will switch each time you press the button.[NORMAL] Set when high luminance is required.[ECO SAVE1] Reduces average power by approximately 20 % compared to [NORMAL] without affecting thebrightness.[ECO SAVE2] Reduces average power by approximately 30 % compared to [NORMAL] without affecting thebrightness.[LOW] Set when high luminance is not required and you want to save more power.Notef The rate of reduction of power consumption when the eco save mode is set refers to the ratio of average power consumption whenprojecting a “Broadcast” video signal that complies with IEC62087.f When [ECO SAVE1] and [ECO SAVE2] is set, the image may appear differently to [NORMAL].f If you feel that the brightness has decreased with [ECO SAVE2], switching to [ECO SAVE1] may improve the image.f When [LOW] is set, the operating noise can be reduced.f When the VIDEO input is selected, [ECO SAVE1] and [ECO SAVE2] cannot be selected. When [ECO SAVE1] or [ECO SAVE2] is set whileselecting other than VIDEO input, and when the VIDEO input is selected, [LOW] is set.f When [PICTURE MODE] is [NATURAL] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may not conform to sRGBstandards.f When [PICTURE MODE] is [REC709] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may not conform to REC709standards.f When [PICTURE MODE] is [DICOM SIM.] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may be displayed differentfrom DICOM standards.