Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 79Setting the date and time automatically1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [ADJUST CLOCK].4) Press the button.f The [ADJUST CLOCK] screen is displayed.5) Press as to select [NTP SYNCHRONIZATION], and press qw to change the setting to [ON].f The items will switch each time you press the button.[OFF] Disables [NTP SYNCHRONIZATION].[ON] Enables [NTP SYNCHRONIZATION].6) Press as to select [APPLY], and press the button.f The setting of the time will be completed.Notef To set the date and time automatically, the projector must be connected to the network.f If synchronization with the NTP server fails just after [NTP SYNCHRONIZATION] is turned [ON], or if [NTP SYNCHRONIZATION] is turned[ON] while the NTP server is not set, [NTP SYNCHRONIZATION] will return to [OFF].f Access the projector via the web browser to set the NTP server. Refer to “[Adjust clock] page” (x page 97) for details.[SAVE ALL USER DATA]Save the various setting values as a backup in the built-in memory of the projector.1) Press as to select [SAVE ALL USER DATA].2) Press the button.f The [SECURITY PASSWORD] screen is displayed.3) Enter a security password and press the button.4) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.f [PROGRESS] is displayed while saving data.Notef The image setting registered in [USER LOGO] is not saved.[LOAD ALL USER DATA]Load the various setting values saved as a backup in the built-in memory of the projector.1) Press as to select [LOAD ALL USER DATA].2) Press the button.f The [SECURITY PASSWORD] screen is displayed.3) Enter a security password and press the button.4) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.Notef The projector will go into the standby status to reflect the setting values when [LOAD ALL USER DATA] is executed.