Chapter 4 Settings — [NETWORK] menu88 - ENGLISH7) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.Notef Not compatible with 10BaseT Full/Half.When the projector is connected directly via a twisted-pair-cable transmitter1) Press as to select [DIGITAL LINK SETUP].2) Press the button.f The [DIGITAL LINK SETUP] screen is displayed.3) Press as to select [DUPLEX(DIGITAL LINK)].4) Press qw to switch the communication method.f The items will switch each time you press the button.[100BaseTX-Full] Full duplex communication method is set.[100BaseTX-Half] Half-duplex communication method is set.[AUTONEGOTIATION] The communication method is set automatically.5) Press as to select [STORE].6) Press the button.7) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.[DIGITAL LINK STATUS]Display DIGITAL LINK connection environment.1) Press as to select [DIGITAL LINK STATUS].2) Press the button.f The [DIGITAL LINK STATUS] screen is displayed.[LINK STATUS] Display [NO LINK], [DIGITAL LINK], or [ETHERNET].[HDMI STATUS] Display any one of [NO HDMI], [HDMI ON], or [HDCP ON].[SIGNAL QUALITY][SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes togreen, yellow, or red depending on the value.Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.f MAX/MIN: Maximum/minimum value of the amount of error.f Green (- 12 dB or lower) → Normal signal quality level.f Yellow (- 11 to - 8 dB) → Warning level where there is the possibility of noise introduced on thescreen.f Red (- 7 dB or higher) → Abnormal level where synchronization may interrupted, or a signal maynot be received.