Chapter 3Basic Operations—Operating with the remote controlENGLISH - 37Switching the inputThe input for projection can be switched.button1)Press the input selection (, , fThis operation can be also performed using the button on the control panel.Switches to COMPUTER input.Switches to DVI-I input.Switches to VIDEO input.Switches to DIGITAL LINK input.Switches to HDMI input.NotefWhen the optional digital interface box (Model No.: ET-YFB100G) is connected to the terminal, the ET-YFB100G inputchanges with each press of the button.For twisted-pair-cable transmitters of other companies, switch the input on the twisted-pair-cable transmitter after switching to DIGITAL LINKinput.Using the Automatic setup functionThe automatic setup function can be used to automatically adjust the resolution, clock phase, and image position when analog RGB signalsconsisting of bitmap images such as computer signals are being input, or to automatically adjust the image position when DVI-D/HDMI signalsare input. Supplying images with bright white borders at the edges and high-contrast black and white characters is recommended when thesystem is in automatic adjustment mode.Avoid supplying images that include halftones or gradation, such as photographs and computer graphics.button1)Press the button.f[COMPLETE] is displayed when it has completed without any problem.NotefThe clock phase may shift even if it has completed without any incident. In this case, adjust with the [POSITION] menu→[CLOCK PHASE](xpage52).fIf an image with blurred edges or a dark image is input, [INCOMPLETE] may appear or adjustment may not be performed properly evenwhen [COMPLETE] appears. In this case, adjust the settings in the [ADVANCED MENU] menu→[INPUT RESOLUTION] (xpage55),[POSITION]→[CLOCK PHASE] (xpage52), [SHIFT] (xpage50).fAdjust special signals according to the [DISPLAY OPTION] menu→[AUTO SETUP] (xpage60).fAutomatic adjustment may not work depending on the model of the computer.fAutomatic adjustment may not work for a synchronization signal of C-SY or SYNC ON GREEN.fImages may be disrupted for a few seconds during automatic adjustment, but it is not a malfunction.fAdjustment is required for each input signal.fAutomatic adjustment can be canceled by pressing the button or the operation.fIf the automatic setup function is performed while moving images are being input, the adjustment may not be performed properly even foran RGB signal for which automatic setup can be used. [INCOMPLETE] may appear, or adjustment may not be finished properly even if[COMPLETE] appears.